Manual - AEQ International

More documents

Recommendations

Info

The bottom of the workspace in this submenu contains two options:• “Delete Routing”: eliminates the selected cross-point. Confirmation is requested.• “Insert Routing”: you can create a cross-point through a simple process that allowsyou to select an input channel or an internal summing bus as the source, and an outputchannel or an internal summing bus as the destination. These names or labels havebeen previously defined in the “I/O Configuration” submenu.AEQ CAPITOLUltra-compact digital audio mixer74
4.3.2. “Programmable Keys” submenu.“Programmable Keys” submenu is accessed, from the drop-down menu “ProgrammableConfiguration”, by clicking on the icon:“Programmable Keys” submenu lets you configure the actions associated with each of the 15programmable keys found in the Control and Monitoring section of the AEQ CAPITOL controlsurface (please refer to Section 2.1.2.2 of this manual).Within this submenu there are two distinct areas:• “Keyboard”: it’s the upper part of the screen that allows for the basic configuration ofthe 15 programmable keys.• “Key Configuration”: it’s the lower part of the screen where the specific configurationof each of the 15 programmable keys is accomplished.4.3.2.1. Basic configuration of programmable keys.This basic configuration section shows graphically the programmable keys corresponding to theControl and Monitoring section of the AEQ CAPITOL control surface. The programmable keysare numbered from 1 to 15 following the order from left to right and top to bottom.To set a programmable key, simply click on it with the mouse and select from the list on the rightto associate action. The available options are:AEQ CAPITOLUltra-compact digital audio mixer75
Page 5:
Its Ethernet port enables the local
Page 8:
In addition to the signals on chann
Page 12 and 13:
VU metersPROGRAMMABLEKEYSMAINSCREEN
Page 14 and 15:
At most, the last line will have fo
Page 16 and 17:
• The three rotary encoders, from
Page 18 and 19:
2.1.3. Wrist- rest and side trims.A
Page 20 and 21:
2.2.1. Power supply.The power suppl
Page 22 and 23:
• Maximum power: 100mW at 40 ° C
Page 24 and 25: 2.2.2.3. Control and studio monitor
Page 26 and 27: - Opening the unit.It’s VERY IMPO
Page 28 and 29: Digital input 4 Digital input 3 Dig
Page 30 and 31: “ANALOG IN 1-4” connectorPin Si
Page 32 and 33: MIC/LINE input 4 MIC/LINE input 3 M
Page 34 and 35: 2.2.4.2. CA33 telephone hybrid opti
Page 36 and 37: 3. DESCRIPTION OF THE INTERNAL MENU
Page 38 and 39: • “CHRONO”: enables you to co
Page 41 and 42: • “BACK”: pressing this key a
Page 43 and 44: 3.4.3. “SELECT“ menu.This menu
Page 45 and 46: The “Compressor / Limiter” func
Page 47 and 48: In addition, the threshold must be
Page 49 and 50: • In mic/line channels, indicatio
Page 51 and 52: • Indication of audio signal type
Page 53 and 54: Only the users defined as administr
Page 55 and 56: There are two distinct areas in thi
Page 57 and 58: The “Unlock” button allows you
Page 59 and 60: The lower part of the “User Confi
Page 61 and 62: 4.2.1. “Board Configuration” su
Page 63 and 64: o“TH02”: GPI to accept the part
Page 65 and 66: The mixer bus configuration table h
Page 67 and 68: 4.2.3.1. Advanced configuration of
Page 69 and 70: • “Mono”: allows you to defin
Page 71 and 72: 4.2.4.1. “Studio Room Section“.
Page 73: 4.3. “Programmable Configuration
Page 77 and 78: • “Latch Mode”: allows you to
Page 79 and 80: 4.3.2.4. Configuration of “Codec
Page 81 and 82: • “On Air GPI”: selects and c
Page 83 and 84: The lower part of the “Programmab
Page 85 and 86: The three buttons at the bottom of
Page 87 and 88: Allows you to scroll to the top of
Page 89 and 90: • “ATTACK TIME”: this is the
Page 91 and 92: 4.3.4.4. Advanced configuration of
Page 93 and 94: The available options in the snapsh
Page 95 and 96: From left to right and from top to
Page 97 and 98: 4.4. “Firmware Upgrade” menu.Th
Page 99 and 100: In case you select an AFU file that
Page 101 and 102: 5. A.E.Q. GUARANTEE.AEQ warrants th
show all

Manual - AEQ International

Create successful ePaper yourself

Delete template?

Save as template?