Manual - AEQ International
Manual - AEQ International
Manual - AEQ International
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Pin Signal Pin Signal1 Not connected 9 Not connected2 GND 10 GND3 Not connected 11 Not connected4 GND 12 GND5 Active Studio Hphones Left 13 Active Studio Hphones Left6 GND 14 GND7 Active Studio Hphones Right 15 Active Studio Hphones Right8 GNDIn order to use this output, connect the headphones as follows:• For left channel, use DB15 pin 5 or 13 and connect the headphone betweenthat point and the external shield (pin 6).• For right channel, use DB15 pins 7 or 15 and connect the headphone betweenthat point and the external shield (pin 6).In order to make installation process easier, <strong>AEQ</strong> offers specific pre-fabricated cable kits for<strong>AEQ</strong> CAPITOL audio input/output, both analog and digital, as well as studio headphones: FRCAB INP, consisting in a male DB15 connector soldered to 4 balanced and shielded 6 meterslong paired cables with no connectors at the other end, for 4 inputs or outputs. For moreinformation please check chapter 2.2.6 of this manual.<strong>AEQ</strong> can upon request provide fully finished cables and in special lengths. For more informationplease refer to <strong>AEQ</strong> sales department or authorised distributors.2.2.3. Generic audio inputs and outputs.Next the available generic inputs and outputs types are detailed:• ”AES IN”: 4 stereo digital AES/EBU or S/PDIF inputs.• ”AES OUT”: 4 stereo digital AES/EBU or S/PDIF outputs.• ”ANALOG IN”: 12 mono line-level inputs, paired to stereo by software.• ”ANALOG OUT”: 8 mono line-level outputs, paired to stereo by software.• ”MIC/LIN”: 4 selectable line or microphone inputs.• ”USB”: 2 stereo USB digital audio inputs/outputs for PC.2.2.3.1. Accessing the programming jumpers.IMPORTANT NOTE: Previous experience with installation and configuration of electronic or PCcards is required for access and reconfiguration of programming jumpers. Please don’t open theunit if you don’t have this experience, due to the risk of causing damages or suffering electricdischarges.AES IN inputs and AES OUT outputs are configured according to AES/EBU standard bydefault. If connection to S/PDIF equipment is needed, you must open the audio engine andchange the corresponding jumpers.Mic/Line inputs are configured for use with dynamic microphones with no phantom feed bydefault. If you need to connect Phantom-fed condenser microphones to these inputs or usethem as mono Line inputs, you must open the audio engine and change the correspondingjumpers.<strong>AEQ</strong> CAPITOLUltra-compact digital audio mixer25
Change language