Manual - AEQ International

• “BACK”: pressing this key allows you to return to the previous menu screen.• “INFO”: essentially a maintenance menu displaying information about the IP address ofthe “LAN” network port present in the rear panel of the unit and firmware versionsinstalled in the several console operating modules, as well as the routing and processDSPs percentage of use.• “SETUP”: which displays and allows you to change the IP configuration associated withthe Ethernet port available on the rear panel of the equipment (“LAN”: see section2.2.2.2 of this manual) in the form of IP address, subnet mask (MASK) and gateway(GWAY). Only level 3 users can modify these parameters (the “SETUP” key is shown toother users but is not active).• “SELECT”: advanced configuration of audio inputs/outputs, internal routing andprocesses.3.4.1. “INFO“ menu.This is a menu specifically for technical maintenance. The “INFO” menu lets you display the IPconfiguration associated with the Ethernet port available on the rear panel of the equipment(“LAN”: IP address, subnet mask and gateway are shown), the firmware versions installed in theseveral console operating modules and the routing and process DSPs percentage of use.The three options visible on the last line of the display are associated with three of the fourcontextual keys below, from left to right:• “BACK”: pressing this key allows you to return to the previous menu screen.• “FIRMW”: in successive screens, which are accessed by turning any of the associatedencoders, you can display the firmware versions installed in the different modules thatmake up the console: the 4 modules that make up the main board of the console (CPU,FPGA, Routing DSP and Process DPS) are shown as “MAIN BOARD” and the MSCmodule is shown as “CONTROL SURFACE”.Each line is identified by the specific module and its reference, as well as the versionand the date of the currently installed specific firmware.AEQ CAPITOLUltra-compact digital audio mixer41