Admin Guide - VoIP software provider

MinMonthlyMinutes: this packet will run on higher priority until the min minutes is reachedPrice: default minute price if not set in tb_packetprices (deprecated. Loaded from pricelist from v.3.2)BillingStep: second increments (used for calculation simcards minutes –daily, weekly, peak, offpeak)MinAmmount: min billing seconds (used for calculation simcards minutes –daily, weekly, peak, offpeak)FreeAmmount: free speech seconds (used for calculation simcards minutes –daily, weekly, peak, offpeak)MinCreditOnRoute: if the sim has less credit, then we don‟t route call to itMinCreditOnCharge: if the sim has less credit, then we begin trying to charge itPrepaid: 0=postpaid, 1=prepaidSendFakeSMS: we send dummy sms on this simCanCallEachOther: the simcard in this packet will call each other periodically to generate incoming trafficIncludeVAT: used when credit message information are received from simcards (typically via SMS) and the simcards credits are calculated without the VAT valueCurrency: used when the credit messages received needs to be converted in native currency (“currency” global setting) format. If the currency is not the same asthe native currency and the “convertsimcreditcurrency” global setting is set to true, than the received credit value is converted to the native currency, based on“Currency Converter” settings, found in MManage under the “Billing” sectionMaxAlloc: helper settings when automatically alocating channels for a direction. (Depending on reserverfor simcard setting).Here you can define the maximum count of simcards that can be reserved for the actual packet. Set to 0 to disable rezerving from that packet.Credit Request Command: the command used by the server for sim credit request (used for recharge automation)Credit Charge Command: the command used by the server for sim credit charge (used for recharge automation)The request and the charge command must have the following syntax: The “chargecode” string in the message will be replaced with a valid code if found.You can introduce delays by inserting „#‟ characters in the message.The action parameter can be-0: used to send USSD messagesThe message parameter must have the following format “AT+CUSD=command” where command is the ussd string.Example: DTMF,0,simid,"AT+CUSD=1,*121*chargecode#"-1: will send the specified message to the engine. The message can be any valid AT command-2: will dial the specified telnum, and then send the message as DTMF.If the message string if empty, than only will dial the requested telnum, hold a little and then drop.Example: DTMF,2,simid,"",172-3: reserved for future usage-4: will send the specified message as SMS to telnum