Admin Guide - VoIP software provider

Dbbackupdir: database backup directorydbdelbackupdir1, dbdelbackupdir1, dbdelbackupdir3: database backup subdirectoriesThis feature is useful, when the database engine doesn‟t have cleanup feature.5.73. Sales commissionsThe sales cost will be calculated to the CDR record “costsales” field. So you can build any statistics based on this value.Every user can have the “Added By” field filled, wich will point to the sales person where the user belongs.You can define the sales commission explicitly in the “Price setup” form (Type must be set to “Sales cost”)If no such price is defined, than the sales commission will be loaded from the actual sales user setting.The defined commission percent will be calculated for the profit or for the enduserprice. This behavior can be set by the“salescomissionfromprofit” global config.Sales can give up for the users some reduction wich will be substracted from their cost. This can be configured with the “reduction” value for theindividual endusers.5.74. Multihomed setupUDP ports must be binded to different ip interface (at least the default sip port 5060), or set to different values.TCP ports must be setup differentlyOn the gsm gateway set the serverip to the binded ip and the cmdport to the gsmclientportChange the pipename setting in the gatekeeper.ini5.75. How to scan your SP for live numbersThe scanner thread can be used to initiate phone calls to a range of phone numbers and will store the validity status of these number inCDR records.Phone numbers can be specified by a range (scan_from, scan_untill) or loaded from a text file (scan_filepath).The speed of the thread can be controlled by the following options: scan_callival, scan_callsperminute, scan_maxcalls (you might specify allthese 3 constrains for a better control).If there is no error in the configuration, the scanner thread will start immediately withing 2 minutes after service startup.Otherwise the scanner can be started/stopped with the “checkscanner” console command (will start if the parameters are ok and scan_enable