Admin Guide - VoIP software provider

RouteRtpCaller: routing mode if this endpoint is the caller0=check called settings –this is the preferred settings1=don't touch the sdp and the rtp2=sdp correction if necessary3=route rtp if both behind nat4= route rtp if caller is behind nat5= route rtp if called is behind nat6= route rtp if any endpoint is behind nat7=always route rtpRouteRtpCalled: routing mode if this endpoint is the called0=check caller settings1=don't touch the sdp and the rtp2=sdp correction if necessary –this is the preferred settings3= route rtp if both behind nat4= route rtp if caller is behind nat5= route rtp if called is behind nat6= route rtp if any endpoint is behind nat7=always route rtpRtp settings will be checked first for the called and then the caller (so if the caller RouteRtpCaller settings is not 0, then it will overwrite the calledRouteRtpCalled settings)RtpIp: last rtp ipRtpPort: last rtp portServerRtpPort: last bind (we try to use the same for every user)NatDetected: 0= no and don‟t change, 1=no but can be changed, 2=yes but can be changed, 3 yes, and don‟t change itNatDetectDisabled: deprecatedStatus: 0=inactive,1=registered, 2=speaking (if statusdate is too old, then treat as 0)StatusDate: last status changeCalledNumber: last called numberCalledID: last called idDiscount1: discount percent. users can have discounts in for max 3 directionsDirection1: prefix. users can have discounts in for max 3 directionsDiscount2: discount percent. users can have discounts in for max 3 directionsDirection2: prefix. users can have discounts in for max 3 directionsDiscount3: discount percent. users can have discounts in for max 3 directions