Admin Guide - VoIP software provider

check if called if a sipuser (Username, telnumber, short telnumber)check the forwardalways optioncheck the ringgroup optionsetup called endpoint if foundget time variables (peak, holiday, etc)Get the correct routing patternCheck routing list in priority orderIf simpacket found, than Check simroutingDrop the call if no route found4.4.9. RADIUSDefine the radius servers, protocol and login information here. Used for authorization and billing.4.4.10. BRSShort name for “Best Route Selection”.In addition to LCR (Least Cost Routing), the Mizu routing engine can take in consideration the quality of the route.If you would like only LCR, simply set the “Quality Percent” field to 0.If we put some directions with equal priority in the pattern, then the system will choose the routing automatically depending on price and quality,when other settings don't modify the routing (min/max minutes, gw/sim priorities, failovered directions, etc)The server automatically calculates am „autopriority” on every route. This priority is the combination of the quality and the price. The quality iscalculated as an average of daily asr/acl and monthly asr/acl. The price is calculated to pricecalcsec seconds with the given minammount andbillingstep (from packet prices). The server route the traffic on the higher priority direction, BUT it will try the other routes periodically (to checkif quality have changed). You can change this „next time try” setting by changing the values of TryedCount,NextTry, NextTryCount. If the bestquality gateway for a route will change, then we will reset TryedCount,NextTry and NextTryCount values to their defaults. (so we can recheckquicker)