Buffalo Wild Wings

Buffalo Wild WingsPART 2 PRODUCTS2.01 BATT INSULATION MATERIALSA. (INSUL1) Batt Insulation: ASTM C 665; preformed mineral fiber batt; friction fit, conforming tothe following:1. Combustibility: Non-combustible, when tested in accordance with ASTM E 136, except forfacing, if any.2. Thickness: As indicated on Drawings for wall thickness.3. Facing: Unfaced.4. Manufacturers:a. CertainTeed Corporation: www.certainteed.comb. Johns Manville Corporation: www.jm.comc. Owens Corning Corp: www.owenscorning.com5. Substitutions: See Section 01600 - Product Requirements.2.02 BOARD INSULATION MATERIALSA. (INSUL2): Under Slab and Foundation Insulation: Extruded Polystyrene Board Insulation, 2”inch thick, unless noted otherwise, ASTM C 578, Type IV, 30 psi minimum compressivestrength, 1.60 lb/cu. ft., with a flame-spread of 5 and smoke-developed indexes of 45-75:1. Manufacturers:a. Diversifoam Products: Certifoam.b. Dow Chemical: Styrofoam.c. Owens Corning: Foamular LT30.B. (INSUL3): Roof Insulation: Polyisocyanurate board to ASTM C 1289, Type II, Class I, Grade2; rigid, closed cell type, with specially formulated organic/inorganic facers.1. Long Term Thermal Resistance (ASTM C518): R=6.0 per 1 inch of thickness.2. Board Size: 48”x48” and 48”x96”.3. Nominal Product Thickness: 4 inches unless noted otherwise.4. Compressive Strength (ASTM D1621): minimum 20 psi.5. Density (ASTM D1622): 2 pcf.6. Edges: Square.7. Dimensional Stability: less than 2 percent linear change.8. Flame Spread (ASTM E84): 25.9. Provide tapered insulation boards and thicknesses to create tapered areas as indicated onRoof Plan.10. Manufacturers and Products:a. Johns Manville: Enrgy 3 Roof Insulation Board. www.jm.comb. GAF Materials Corporation: EnergyGuard Roof Insulation Board. www.gaf.comc. Firestone Building Products: ISO 95+. www.firestonebpco.comd. Comparable products from other roofing insulation manufacturers that meet or exceedthe specified requirements and are acceptable to the roof membrane manufacturer.C. Mechanical Fasteners: Screw type, 6 ga. diameter, self-tapping, galvanized steel, sufficientlength to secure anchor system into place and to withstand all super-imposed loads: completewith 1 1/2 inch diameter 14 ga. thick galvanized steel discs.PART 3 EXECUTION3.01 EXAMINATIONA. Verify that substrate, adjacent materials, and insulation materials are dry and compatible.B. Verify substrate surfaces are flat, sound, free of honeycomb, oil, grease, fins, or otherirregularities.03/09/10 BOARD AND BATT INSULATION07212 -2