Buffalo Wild Wings

Buffalo Wild Wings1.05 QUALITY ASSURANCEA. Manufacturer Qualifications: Provide all products from a single manufacturer who is a memberof the Steel Door Institute.B. Manufacture products only after receipt of approved hardware schedule and templates.1.06 DELIVERY, STORAGE, AND HANDLINGA. Upon delivery, inspect all materials for damage; notify shipper and supplier if damage is found.B. Protect products from moisture, construction traffic, and damage.C. Store vertically under cover. Do not use non-vented plastic or canvas shelters. Shouldwrappers become wet, remove immediately.D. Place units on 4 inch high wood sills or in a manner that will prevent rust or damage. Provide1/4 inch space between doors to promote air circulation.PART 2 PRODUCTS2.01 DOOR AND FRAME SUPPLIERA. Hollow metal doors and frames are to be furnished by the General Contactor through Twin CityHardware as part of the current BWW Door and Hardware Package.2.02 MANUFACTURERSTwin City Hardware Company723 Hadley Avenue NorthOakdale, MN 55128651-735-2200A. Ingersoll Rand, Steelcraft.2.03 MATERIALSA. Steel Sheet for Doors and Frames:1. Cold rolled steel: ASTM A 1008/A 1008M, Designation CS.2. Hot rolled steel: Pickled and oiled, ASTM A 1011/A 1011M, Designation CS Type B.3. Galvanized steel: Hot-dipped, ASTM A 653/A 653M, with G60/Z180 coating, minimum.B. Steel Sheet for Anchors and Accessories: Electrolytically deposited zinc coated steel; ASTM A591/A 591M, coating 40Z (12G), minimum.C. Accessory Materials:1. Rubber Door Silencers: Furnish three at each single leaf door frames and two at each pairsof doors.D. Glazing: Comply with requirements in Section 08800 Glazing.2.04 HOLLOW METAL FRAMESA. General: Comply with requirements of ANSI/SDI A250.8.B. Exterior Frames: Fabricate frames from metallic-coated steel sheet assembled with amechanical interlock joint, face miter seam “closed and tight”. Weld face seam and full web offrame (T-3). Grind and dress smooth weld area. Apply zinc rich primer over grinding area.1. Sheet Thickness: 14 gauge.2. Material and Finish: Zinc-alloy-iron coating (galvannealed) to a minimum coating weight ofA60 to comply with ASTM A 653.3. Galvanize internal members and reinforcements.04-27-11 HOLLOW METAL DOORS AND FRAMES08110 -2