Buffalo Wild Wings

Buffalo Wild WingsPART 2 - PRODUCTS2.01 MANUFACTURERSA. Acceptable Manufacturers and Products:1. Alcoa Architectural Products: Reynobond ACM. www.alcoaarchitecturalproducts.com2. Firestone Metal Products: Una-clad Series 1000UC Aluminum Composite Panel System.www.unaclad.com3. Mitsubishi Plastics Composites, Inc.: Alpolic Composite Metal Panels.www.alpolic-usa.com2.02 MATERIALSA. Aluminum Sheet: Coil-coated sheet, ASTM B 209, alloy as standard with manufacturer, withtemper as required to suit forming operations and structural performance required.1. Surface: Smooth, flat finish.2. Exposed Coil-Coated Finishes:a. Metallic Fluoropolymer: AAMA 620. 3-coat fluoropolymer finish with suspendedmetallic flakes containing not less than 70 percent PVDF resin by weight in both colorcoat and clear topcoat. Prepare, pre-treat, and apply coating to exposed metalsurfaces to comply with coating and resin manufacturers' written instructions.3. Concealed Finish: Apply pretreatment and manufacturer's standard white or light-coloredacrylic or polyester backer finish, consisting of prime coat and wash coat with a minimumtotal dry film thickness of 0.5 mil.B. Panel Sealants:1. Joint Sealant: ASTM C 920; elastomeric silicone sealant; of type, grade, class, and useclassifications required to seal joints in composite panels and remain weathertight; and asrecommended in writing by panel manufacturer.a. Sealant Color: Color to match panel color.2.03 MISCELLANEOUS METAL FRAMINGA. Panel System Subgrits: Provide galvanized steel of gauge and spacing required for panelsystem structural requirements, as recommended by panel manufacture and in accordance withapproved shop drawings. To avoid galvanic reaction, separate dissimilar metals.B. Fasteners for Miscellaneous Metal Framing: Of type, material, size, corrosion resistance,holding power, and other properties required to fasten miscellaneous metal framing members tosubstrates.2.04 COMPOSITE PANELSA. General: Provide factory-formed and assembled, aluminum faced composite panels fabricatedfrom two metal facings bonded, using no glues or adhesives, to solid, extruded thermoplasticcore; formed into profile for installation method indicated. Include attachment systemcomponents and accessories required for weathertight system.B. Aluminum Composite Panels: Formed with 0.020-inch thick, coil-coated aluminum sheetfacings.1. Panel Thickness: 4 mm.2. Core: Standard.3. Exterior Finish: 3-coat Metallic fluoropolymer.4. Color: Una-Clad “Silver Metallic”.a. Comparable color from the other specified composite panel manufacturer’s with colorsamples approved by Architect.04-27-11 ALUMINUM COMPOSITE PANEL SYSTEM07424 -3