Buffalo Wild Wings

Buffalo Wild Wings2.02 MATERIALSA. Manually Operated Roller Shade System: MechoShade 5 consisting of the followingcomponents:1. Brackets and operating assembly consisting of 1/8" steel and molded Delrin. Bead chaindrive operated Delrin drive bracket.2. Stainless Steel Chain: 90 lb. test, and hold-down brackets.3. Provide upper and lower stop limits.4. Shade Mounting System: extruded 6063T6 aluminum tube with a wall thickness of .100"with asymmetrically shaped channels in which a matching snap-on vinyl spline can bemounted.a. Spline and shade to be easily removable and replaceable without disassembling thehardware.b. Attachment of the shade band shall not be with adhesives or staples.5. Shades to be full width of windows as indicated. Splitting shades within one window will notbe allowed.a. Provide lift assist mechanism for shades in excess of 5 pounds.b. Provide shade cloth clearance of 1/4" on idle end and 9/16" on the drive end.B. Shade Fabric: EuroTwill Shade Cloth; Series 6000.1. Fabric Color: No. 6012, “Charcoal”.2. Fabric to pass Class I Flame Spread per ASTM E-84 and large or small Vertical BurnRequirements of NFPA 701.2.03 ACCESSORIESA. Aluminum Fascia Units: Manufacturer's standard “L” shaped, snap-on, extruded aluminumfascia units as follows:1. MechoShade SnapLoc Fascia, for regular roll installation mounted on front of shade roll.2. End Caps: Provide pre-finished end caps where mounting conditions expose outside ofroller shade brackets.3. Fascia Finish: Both fascia units and end caps as applicable to be factory finished.a. Color: Clear anodized to match window frames.B. Chain Tension Pulley: Manufacturer's standard chain tension pulley.1. Color: Clear anodized.C. Provide mounting brackets and other components required for complete installation.2.04 FABRICATIONA. Fabricate shades square with a snap-on spline for mechanical fastening directly to mountingtube. Staples and tape are not allowed.B. Provide a weighted hembar, heat sealed within the shade. No loose hembar will be allowed.C. Cut shade cloth by means of an edge-sealing hot-knife.D. Fabricate shade system with set stop positions at upper and lower limit points.PART 3 EXECUTION3.01 EXAMINATIONA. Verification of Conditions: Examine areas and conditions under which Work is to be performedand identify conditions detrimental to proper and timely completion.1. Do not proceed until unsatisfactory conditions have been corrected in a manner acceptableto installer.2. Beginning the installation indicates the installer accepts the substrate.04-27-11 WINDOW SHADES12493 -2