Buffalo Wild Wings

Buffalo Wild WingsC. ICC Evaluation Service, Inc. (ICC-ES):1. ICC-ES AC12: Interim Criteria for Foam Plastic Insulation.2. ICC-ES AC24: Interim Criteria for Exterior Insulation and Finish System.3. ICC-ES AC219: Acceptance Criteria for Exterior Insulation and Finish System.1.05 PERFORMANCE REQUIREMENTSA. EIFS Performance: Provide a system to comply with the following:1. Bond Integrity: Free from bond failure within EIFS components or between system andsupporting wall construction, resulting from exposure to fire, wind loads, weather, or otherin-service conditions.2. Weathertightness: Resistant to water penetration from exterior into water-drainage EIFSand assemblies behind it or through them into interior of building that results indeterioration of thermal-insulating effectiveness or other degradation of EIFS andassemblies behind it, including substrates, supporting wall construction, and interior finish,and including a means that allows water entering into an EIFS assembly to drain to theexterior.B. Class PB EIFS: Provide EIFS having physical properties and structural performance thatcomply with the following:1. Abrasion Resistance: No cracking, checking, or loss of film integrity when tested perASTM D 968, Method A.2. Absorption - Freeze Resistance: No visible deleterious effects and negligible weight lossafter 60 cycles per EIMA 101.01.3. Accelerated Weathering: Five samples per ICC-ES AC219 showing no cracking, checking,crazing, erosion, rusting, blistering, peeling, delamination per ASTM G 153.4. Freeze -Thaw: No surface changes, cracking, checking, crazing, erosion, rusting,blistering, peeling, or delamination per ICC-ES AC219.5. Mildew Resistance of Finish Coat: No growth when tested per ASTM D 3273 andevaluated according to ASTM D 3274.6. Salt-Spray Resistance: No deleterious affects when tested according to ICC-ES AC219.7. Tensile Adhesion: No failure in EIFS, adhesive, base coat, or finish coat when tested perEIMA 101.03.8. Water Penetration: No water penetration into the plane of the base coat to expandedpolystyreneboard interface per EIMA 101.02.9. Water Resistance: No cracking, checking, crazing, erosion, rusting, blistering, peeling, ordelamination after testing for 14 days per ASTM D 2247.10. Wind-Driven-Rain Resistance: When applicable with stud framed wall substrates; resistwind-driven rain according to ICC-ES AC219.11. Impact Resistance: Tested per EIMA 101.86; and meeting or exceeding the following:12. Standard Impact Resistance: 25 to 49 inch-lb.13. High Impact Resistance: 90 to 150 inch-lb.14. Drainage: According to ICC-ES AC235.15. Structural Performance Testing: EIFS assembly and components to comply with ICC-ES AC219 when tested per ASTM E 330.1.06 SUBMITTALSA. See Section 01300 - Administrative Requirements, for submittal procedures.B. Installer’s Certification:1. List of at least 3 successfully completed EIFS projects of similar complexity, completedwithin the last 2 years.2. Installer’s approved and current Applicator’s Certificate.1.07 QUALITY ASSURANCEA. Installer Qualifications: Installer, certified in writing by EIFS manufacturer as qualified to installmanufacturer's system using trained workers.12/28/10 EXTERIOR INSULATION AND FINISH SYSTEM07240 -2