Buffalo Wild Wings

Buffalo Wild Wings4. Semigloss: refers to medium-sheen finish; MPI Classification “Gloss Level 5”.a. Gloss range between 35 and 70 when measured at a 60-degree meter.5. Full Gloss: refers to high-sheen finish; MPI Classification “Gloss Level 6”.a. Gloss range between 70 and 85 when measured at a 60-degree meter.C. Paint System (PS#): Two or more coats of paint, generally consisting of a prime coat and oneor more coats of finish paint.1. Paint system includes surface preparation and required pre-treatment.D. Color (C#): Identified by a number after an abbreviation "C".1.05 SUBMITTALSA. See Section 01300 - Administrative Requirements, for submittal procedures.B. Color Samples: Submit for approval (2) two paper-backed samples, standard draw-down type,of each color and sheen combination indicated. Samples will be reviewed for sheen as well asfor color.1. Clear or semi-transparent wood finishes if specified: Submit on wood specified, as acomplete system with stain if any.C. Product Data: For each paint system indicated. Include primers and miscellaneous materials.1. Material List: An inclusive list of required coating materials.a. Indicate each material and cross-reference specific coating, finish system, andapplication.b. Identify each material by manufacturer's catalog number and general classificationand color number.2. Manufacturer's Information: Manufacturer's technical information, including label analysisand instructions for handling, storing, and applying each coating material.1.06 QUALITY ASSURANCEA. Applicator's Qualifications: Firm experienced in application or installation of systems similar incomplexity to those required for this Project.B. Regulatory Requirements: Products must meet current local and federal VOC requirements.C. Product Identification: Provide manufacturer's product identification on product containers sameas that on final material list. In addition, provide color identification, analysis of contents,instructions for application and for reducing (if applicable) on containers.1.07 DELIVERY, STORAGE, AND PROTECTIONA. Deliver products to site in sealed and labeled containers; inspect to verify acceptability.B. Container Label: Include manufacturer's name, type of paint, brand name, lot number, brandcode, coverage, surface preparation, drying time, cleanup requirements, color designation, andinstructions for mixing and reducing.C. Paint Materials: Store at minimum ambient temperature of 45 degrees F and a maximum of 90degrees F, in ventilated area, and as required by manufacturer's instructions.1.08 PROJECT CONDITIONSA. Environmental Requirements: Comply with manufacturer's recommendations for conditionsunder which paint systems can be applied, and the following:1. Maintain ambient temperature above 50 degrees F. during and 72 hours after installation.2. Apply water-borne paints when the temperature of surfaces to be painted and surroundingair temperature is between 50 degrees F. and 90 degrees F.3. Apply solvent-thinned paints only when the temperature of surfaces to be painted and thesurrounding air temperature is between 45 degrees F. and 95 degrees F.04-27-11 PAINTS AND COATINGS09900 -2