Buffalo Wild Wings

D. Where locations shown or mounting heights specified for devices conflict with othertrades or building finishes, the Contractor shall coordinate exact requirements prior toinstallation and install only after the approval of all involved.E. Provide spacers as required between outlet boxes and devices so that each device isflush with the finished wall. Plate screws shall not be used to stabilize device.F. Location:3.2 MOVING DEVICES1. Switches near doors shall be located on side opposite the hinges (verify doorswings with Architectural Drawings before installation) and close to door trim.Edge of switch plate shall be within six inches of door frame.A. The Owner, through the Architect/Engineer, reserves the right to move any device adistance of ten feet in any direction from the location shown on the Drawings without anincrease in Contract amount. This requirement shall only apply to devices beforeinstallation.B. In the event that an outlet shown on the Drawings will not be able to serve the specifiedpiece of equipment, the outlet shall be relocated as required, with no increase in contractamount.END OF SECTION 16140WIRING DEVICES16140-3