Buffalo Wild Wings

Buffalo Wild Wings1.04 QUALITY ASSURANCEA. Perform in accordance with ASTM C 840. Comply with requirements of GA-600 for fire-ratedassemblies.B. Applicator Qualifications: Company specializing in performing gypsum board application andfinishing.PART 2 PRODUCTS2.01 METAL FRAMING MATERIALSA. Non-Loadbearing Framing System Components: ASTM C 645; galvanized sheet steel, of sizeand properties necessary to comply with ASTM C 754 for the spacing indicated, with maximumdeflection of wall framing of L/240 at 5 psf.1. Exception: The minimum metal thickness and section properties requirements of ASTM C645 are waived provided steel of 40 ksi minimum yield strength is used, the metal iscontinuously dimpled, the effective thickness is at least twice the base metal thickness, andmaximum stud heights are determined by testing in accordance with ASTM E 72 usingassemblies specified by ASTM C 754.2. Studs: "C" shaped with flat or formed webs with knurled faces.3. Runners: U shaped, sized to match studs.4. Insulation Furring: Z shaped for use with board insulation, 1 1/2 inch.B. Partition Head To Structure Connections: Provide track fastened to structure with legs ofsufficient length to accommodate deflection, for friction fit of studs cut short and fastened asindicated on drawings.C. Partition Head to Structure Connections: Provide mechanical anchorage devices thataccommodate deflection using slotted holes, screws and anti-friction bushings, preventingrotation of studs while maintaining structural performance of partition.1. Structural Performance: Maintain lateral load resistance and vertical movement capacityrequired by applicable code, when evaluated in accordance with AISI North AmericanSpecification for the Design of Cold-Formed Steel Structural Members.2. Material: ASTM A 653/A 653M steel sheet, SS Grade 50/340, with G60/Z180 hot dippedgalvanized coating.2.02 SUSPENDED CEILING COMPONENTSA. Hanger Wire: ASTM A 641/A 641M, Class 1 zinc coating, soft temper, 12 gauge wire.B. Flat Hangers: Steel sheet, 1 by 3/16 inch.C. Tie Wire: ASTM A 641/A 641M, Class 1 zinc coating, soft temper, 18 gauge wire.D. Ceiling Channels: 0.0312-inch, (20 Gauge) base metal thickness, with minimum 1/2-inch wideflanges.1. Depth: 2-1/2 inch.E. Furring Channels: Hat-Shaped, 2-9/16 inch wide with 1-1/4 inch face.1. Minimum Base Metal Thickness: 0.0179 inch, (25 Gauge).2. Depth: 7/8 inch or 1-1/2 inch, as indicated on Drawings.2.03 GYPSUM BOARD MATERIALSA. Acceptable Manufacturers:1. G-P Gypsum Corporation: www.gp.com.2. National Gypsum Company: www.nationalgypsum.com.3. USG Corporation: www.usg.com.4. Substitutions: See Section 01600 - Product Requirements.04-27-11 GYPSUM BOARD ASSEMBLIES09260 -2