Buffalo Wild Wings

Buffalo Wild Wings3.03 INSTALLATION - EXTERIOR/INTERIOR DRY METHOD (GASKET GLAZING)A. Place setting blocks at 1/4 points with edge block no more than 6 inches from corners.B. Rest glazing on setting blocks and push against fixed stop with sufficient pressure on gasket toattain full contact.C. Install removable stops without displacing glazing gasket; exert pressure for full continuouscontact.3.04 INSTALLATION - EXTERIOR DRY METHOD (TAPE AND GASKET SPLINE GLAZING)A. Cut glazing tape to length; install on glazing pane. Seal corners by butting tape and sealingjunctions with butyl sealant.B. Place setting blocks at 1/4 points with edge block no more than 6 inches from corners.C. Rest glazing on setting blocks and push against fixed stop with sufficient pressure to attain fullcontact.D. Install removable stops without displacing glazing spline. Exert pressure for full continuouscontact.E. Trim protruding tape edge.3.05 INSTALLATION - INTERIOR DRY METHOD (TAPE AND TAPE)A. Install Owner supplied 1/4 inch logo glass as indicated on the Drawings.B. Cut glazing tape to length and set against permanent stops, projecting 1/16 inch (1.6 mm)above sight line.C. Place setting blocks at 1/4 points with edge block no more than 6 inches from corners.D. Rest glazing on setting blocks and push against tape for full contact at perimeter of pane or unit.E. Place glazing tape on free perimeter of glazing in same manner described above.F. Install removable stop without displacement of tape. Exert pressure on tape for full continuouscontact.G. Knife trim protruding tape.3.06 MIRROR INSTALLATIONA. General: Install mirrors to comply with mirror manufacturer's written instructions and withreferenced GANA publications. Mount mirrors accurately in place in a manner that avoidsdistorting reflected images.B. Wall-Mounted Mirrors: Install mirrors with mastic and/or mirror clips as applicable. Attachmirror hardware securely to mounting surfaces with mechanical fasteners installed with anchorsor inserts as applicable. Install fasteners so heads do not impose point loads on backs ofmirrors.1. Mirror Clips: Place a felt or plastic pad between mirror and each clip to prevent spalling ofmirror edges. Locate clips so they are symmetrically placed and evenly spaced.2. Install mastic as follows:a. Apply mastic to comply with mastic manufacturer's written instructions for coverage andto allow air circulation between back of mirrors and face of mounting surface.b. After mastic is applied, align mirrors and press into place while maintaining a minimumair space of 1/8 inch between back of mirrors and mounting surface.C. Refer to Drawings for wood trim mirror frames.04-27-11 GLAZING08800 -4