Buffalo Wild Wings

Buffalo Wild Wings2.03 CONCRETE MATERIALSA. Cement: ASTM C 150, Type I - Normal and Type IA - Air-Entraining Portland type.B. Fine and Coarse Aggregates: ASTM C 33.C. Fly Ash: ASTM C 618, Class C or F.D. Calcined Pozzolan: ASTM C 618, Class N.E. Water: Clean and not detrimental to concrete.2.04 CHEMICAL ADMIXTURESA. Do not use chemicals that will result in soluble chloride ions in excess of 0.1 percent by weightof cement.B. Air Entrainment Admixture: ASTM C 260. Provide Daravair manufactured by W. R. Grace.C. Chemical Admixtures:1. Water Reducing: ASTM C 494/C 494M, Type A.2. Retarding: ASTM C 494/C 494M, Type B.3. Accelerating: ASTM C 494/C 494M, Type C.4. Water Reducing and Retarding: ASTM C 494/C 494M, Type D.5. Water Reducing and Accelerating: ASTM C 494/C 494M, Type E.6. Water Reducing, High Range: ASTM C 494/C 494M, Type F.7. Water Reducing, High Range and Retarding: ASTM C 494/C 494M, Type G.2.05 ACCESSORY MATERIALSA. Vapor Retarder: ASTM E 1745, Class C, not less than 10 mils thick. Include manufacturer'srecommended adhesive or pressure-sensitive joint tape.1. Acceptable Manufacturers:a. Raven Industries Inc.; Vapor Block VB10.b. Reef Industries, Inc.; Griffolyn Type- 65.c. Stego Industries, LLC; Stego Wrap, 10 mils.B. Non-Shrink Grout: ASTM C 1107; premixed compound consisting of non-metallic aggregate,cement, water reducing and plasticizing agents.1. Minimum Compressive Strength at 28 Days: 7000 psi.a. Conspec: “Enduro 50 Grout”.b. Euclid: "Euco N-S Grout".c. L & M: "Duragrout".d. Sonneborn: "Sonogrout 10k".e. Five Star Products, Inc.: "Five Star Grout".f. Vexcon Chemicals, Inc.: Certi-Vex Grout #1000.C. Moisture-Retaining Cover: ASTM C 171; regular curing paper, white curing paper, clearpolyethylene, white polyethylene, or white burlap-polyethylene sheet.D. Liquid Curing Compound: ASTM C 309, Type 1, clear or translucent.1. Provide curing compound that is compatible with floor finish adhesives.2.06 BONDING AND JOINTING PRODUCTSA. Joint Filler: Nonextruding, resilient asphalt impregnated fiberboard or felt, complying with ASTMD 1751, thickness as indicated on drawings and full depth of slab less 1/2 inch.B. Sealant and Primer: As specified in Section 07900.04-27-11 CAST-IN-PLACE CONCRETE03300 -3