Sidewinder G2 6.1.2 Administration Guide - Glossary of Technical ...

Chapter 6: Configuring Application Defenses
Viewing Application Defense information
Viewing
Application
Defense
information
154
Figure 69: Application
Defenses window (Web)
To view the Application Defenses windows, in the Admin Console select Policy
Configuration > Application Defenses > Defenses and then select the type of
Application Defense you want to view from the tree. A window similar to the
following appears.
The top portion of each Application Defense window consists of a table that
lists all of the Application Defenses (by row) that are currently configured for a
particular category. The table columns display the individual attributes for the
defenses. Basic default defenses (such as Default and Deny All) are preconfigured
for each category of Application Defense.
Note: The Application Defenses that are displayed in the table will vary depending
on the defense category you select from the tree.
You can perform the following actions in any of the Application Defense
windows:
• Create/modify/delete an Application Defense—To create a new Application
Defense, click New in the upper portion of the window. To create a new
Application Defense based on an existing defense, select the defense that
you want to duplicate, and then click Duplicate. You can then modify the
defense as needed to suit your needs. See “About the New/Duplicate
Application Defense window” on page 156.
To modify an existing Application Defense, select the defense that you want
to modify from the table. The configuration information is displayed in the
bottom portion of the window. To modify the Application Defense in a popup
window format, click Modify.