Sidewinder G2 6.1.2 Administration Guide - Glossary of Technical ...

Chapter 10: Setting Up Authentication
Configuring authentication services
294
Figure 135: SafeWord
Configuration window
About the SafeWord
Configuration
window
Setting up SafeWord authentication
This section describes how to configure your Sidewinder G2 to work with a
SafeWord PremierAccess authentication server for login, SOCKS5, Telnet,
FTP, Web, or SSH authentication.
To configure SafeWord PremierAccess authentication on the Sidewinder G2,
you must first install and configure the SafeWord PremierAccess
Authentication Server. (Refer to the appropriate product documentation.)
To configure SafeWord RemoteAccess authentication, use the RADIUS
warder. See “Setting up RADIUS authentication” on page 292 for more
information.
In the Admin Console select Services Configuration > Authentication, and
click Configure SafeWord. The following window appears.
This window allows you to view and modify your SafeWord PremierAccess
server entries. The SafeWord Configuration tab contains a table with the
following fields:
• Rank—This column indicates which server the Sidewinder G2 will try first.
• Host—This column indicates the host (IP address) for each server entry.
• Port Number—This column indicates the port number for each server entry.
The default port number for SafeWord PremierAccess is 5030. (If you are
configuring a server entry for SafeWord, you will need to change the port to
7482.)
To delete an existing entry, highlight that entry and click Delete.
To create a new server entry, click New. To modify an existing server entry,
highlight the entry you want to modify, and click Modify. See “Adding or
modifying a SafeWord server entry” on page 295 for details.
Note: If you want to use SafeWord PremierAccess authentication after it is
configured, you must also enable it in the Authentication Configuration window.