Sidewinder G2 6.1.2 Administration Guide - Glossary of Technical ...

Chapter 8: Creating Rules and Rule Groups
Creating proxy rules
224
Figure 109: Proxy Rule:
Source/Dest tab
Entering source and
destination
information
The Source/Dest tab is used to enter source and destination restrictions for a
proxy rule. Follow the steps below.
1 [Optional ] To create a network object to use as the source or destination of
this rule, do the following:
a Click New. You will be prompted to select the type of object you want to
create.
b Select the type of network object you want to create and click OK. The
New Network Object window appears.
c Create the network object. When you click Add, you are returned to the
Source/Dest tab in the Proxy Rule window.
Note: For information on creating a Network Object, see “Creating network
objects” on page 139.
2 In the Source Burb drop-down list, select the source burb associated with
this rule.
3 In the Destination Burb drop-down list, select the destination burb
associated with this rule.
Note: When defining inbound address redirection for a rule, you should select
the Internet (external) burb for both the Source Burb and the Destination Burb
fields unless you are redirecting internally, or if you are redirecting inbound to
another internal address.
4 In the Source list that is displayed, select the source object to use for this
rule. (If needed, you can use the Show drop-down list to filter the list to
display only one type of object.)
5 In the Destination list that is displayed, select the destination object to use
for this rule. (If needed, you can use the Show drop-down list to filter the list
to display only one type of object.)