Sidewinder G2 6.1.2 Administration Guide - Glossary of Technical ...

Chapter 10: Setting Up Authentication
Configuring authentication services
296
Figure 136: SecurID
Configuration window
Entering information
on the SecurID
Configuration
window
This window allows you to specify the installation configuration file location.
Follow the steps below.
1 In the Source field, specify whether the configuration file is stored on the
Admin Console (Local File) or on the Sidewinder G2 (Remote File).
2 In the Install Configuration File field, type the path name of the file in which
you stored the ACE Server configuration. This is the same file you imported
in step 2 of “Setting up SecurID authentication” on page 295.
To browse for the location of the configuration file rather than typing it
directly, click Browse.
3 Click OK to save your changes before returning to the Authentication
Configuration window. This assigns the sdconf.rec file the proper Type
Enforcement type and installs the file in the correct Sidewinder G2
directory.
Note: If you want to use SecureID authentication after it is configured, make
sure you enable it in the Authentication Configuration window.
Setting up SecureNet Key (SNK) authentication
To configure your Sidewinder G2 to work with Symantec Defender Security
Server (DSS) for login, SOCKS5, Telnet, FTP, Web, and SSH authentication,
follow the steps below.
Note: Configuring SNK consists of performing some configuration tasks on the
DSS and some on the Sidewinder G2.
On the Defender Security System, do the following:
1 Install the Defender Security Server and Defender Management (DMS)
software. Refer to your Defender documentation for installation information.
If DSS is already installed in your network, you can skip this step.