HP 8648 A/B/C/D - Changpuak.ch

‘Ihble 2-1. Programming Command Statements and Descriptions (continued)
Command Statement
IEEE 488.2 Common Commands
‘RST Resets the signal generator to a default state
(see SCPI Command Reference).
‘WA1
*US
‘ESE
‘OPC
*RCL [,]
‘SAV [,]
‘SRE
Description QU=Y
Returns the instruments identity. ‘IDN?
Executes an instrument self-test. -l-ST?
Instrument waits until previous commands are
completed.
Clears status and event registers.
Enables Standard Event Status Register bits.
Queries the Standard Event Status Enable *ESE?
Register.
Queries the Standard Event Status Register.
Enables the Operation Complete bit of the
Standard Event Status Register.
Queries the Operation Complete bit of the
Standard Event Register.
Recalls the Standard Event Status Register.
is optional in that the last
sequence number that was sent over HP-IB is
stored and that number is used if no sequence
number is used in the command. The power-up
default sequence number is 0.
Saves the Standard Event Status Register.
is optional in that the last
sequence number that was sent over HP-IB is
stored and that number is used if no sequence
number is used in the command. The power-up
default sequence number is 0.
Enables the bits in the Status Byte that will
cause a Service Request.
‘ESR?
‘OPC?
Queries the Service Request Enable Register. ‘SRE?
Queries the Status Byte with the MSS bit. TrB?
HP-IB Programming 2-11