HP 8648 A/B/C/D - Changpuak.ch

I I
I 1
pijti
Setting the Encoding Mode
The number of times a message
transmission are determined by
FREQUENCY 1-1 MOD”LATlON
Function
is transmitted and the level of that
the following menu:
MODE BURST AMPLITUDEO.OdE!m
BURSTS003
MODE determines whether the message will be output once or
multiple times when [SET) (START/STOP) is pressed.
SINGLE: Outputs the message once.
BURST: Outputs the message the number of times specified
in the BURSTS field (3 times in this example).
CONT: Outputs the message continuously until the
:yJ (START/STOP) key is pressed a second
AMPLITUDE sets the signal output level of the carrier.
BURSTS sets the number of times the message will be transmitted.
This parameter is displayed only when the MODE parameter is set to
BURST. The allowable range is 1 to 255.
RF OFF is displayed below the amplitude setting when the RF output
is turned off. To toggle the RF signal output on and off, press
(jj-.
HOLD is displayed when the step attenuator is held at its current
range setting. To toggle the attenuator hold function on and off,
press CATTNj.
Operation Reference lb-31