HP 8648 A/B/C/D - Changpuak.ch

Test Point Extender One additional adapter is required to perform the adjustments.
Several adjustments use 531 as a test point on the motherboard of the
DUT. The adapter is used to extend the 531 test point so that it can be
accessed for the adjustments. The 531 Test Point Extender (HP part
number 08648-60175) and Service Support Software can be obtained,
together, by ordering HP part number 08648-60180.
7.2 Adjustments
You can also build the 531 Test Point Extender by using the following
instructions. 531 is a six-pin connector on the motherboard. The test
point extender consists of a six-pin connector housing attached to
six crimped wires that will plug into 531. The six wires should be of
different colors so that you can differentiate between the wires with
just a glance. A good method of differentiating between the wires is
by using the resistor color code values to identify the pin number. For
example, the value of orange in the resistor color code is “3”; so the
orange wire is connected as pin 3 of the test point extender.
The recommended part numbers for the test point extender are shown
below.
‘hble 7-1. 531 Test Point Extender Forts List
Description
Connector housing, 6-pin
Crimp connectors
Wire, 22AWG, brown (color code value = 1)
Wire, 22AWG, red (color code value = 2)
Wire, 22AWG, orange (color code value = 3)
HP Part Number
1251-5981
1251-5216
8150-0007
8150-0022
8150-0017
Wire, 22AWG, yellow (color code value = 4) 8150-0038
Wire, 22AWG, green (color code value = 5) 8150-001 I
Wire, 22AWG, blue (color code value = 6) 8150-0014
1 foot
_i 1 foot
If you constructed your own test point extender, you can use this
table to record your color code so that it can be readily identified in
the future.
Enter your 531 Test Point Extender Color Code Here
Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6