HP 8648 A/B/C/D - Changpuak.ch

RESYNC
Setting the Encoding Mode
Function
The following parameters must be set to activate the
resynchronization function for a FLEX/FLEX-TD pager under test:
1 n mm/r, 6 tir,‘n\--F=Q-C”- M=‘D”LJJ”ON- . Ah4PLrr”DE
BURSTS 001 AMPLITUDE O.odBm
I I
encode38.drw
BURSTS defines the number of data to make a pager resynchronized
with this pager encoding signal. One burst is 1.92 s. The allowable
range is 000 to 256. 0 represents the continuous mode.
Note This setting is required only when RESYNC is selected in the format
menu. The @) (PREV) and ($‘J (NEXT) keys toggle the format menu
and this BURSTS menu. No other menus are displayed.
Message During Resynchronizing
To start and stop encoding after selecting all pager encoder
parameters, press the [‘NCR) (START/STOP) key.
I
FREQUENCY- MODULATION - AMPLITUDE-
RESYNC SENDING
I I
encode37.dr.v
Note If the RF output is turned off, AMPLITUDE x . xdBm will be substituted
for RF OFF. While encoding, the blinking cursor is on the first
character A of AMPLITUDE or R of RF OFF.
Operation Reference 1 b-33
I
I