HP 8648 A/B/C/D - Changpuak.ch

Function
lb-14 Operation Reference
Setting the Encoding Mode
The number of times a message is transmitted and the level of that
transmission are determined by the following menu:
EmEQ”ENCY - MOD”LATlcm - AMP‘lTUDE
MODE BURST AMFUTUDE O.OdBm
BURSTS 003
MODE determines whether the message will be output once or
multiple times when @iK?‘K] (START/STOP) is pressed.
SINGLE: Outputs the message once.
BURST: Outputs the message the number of times specified
in the BURSTS field (3 times in this example).
CONT: Outputs the message continuously until the
(lNCR] (START/STOP) key is pressed a second
time. (Note: The collapse cycle described later
on in this section will determine how often the
message will be transmitted per cycle.)
AMPLITUDE sets the output signal level of the carrier.
BURSTS sets the number of times the message will be transmitted.
This parameter is displayed only when the MODE parameter is set to
BURST. The allowable range is 1 to 256.
RF OFF is displayed below the amplitude setting when the RF output
is turned off. To toggle the RF signal output on and off, press
(EKGipFON/OFF).
HOLD is displayed when the step attenuator is held at its current
range setting. To toggle the attenuator hold function on and off,
press [ATTNJ