HP 8648 A/B/C/D - Changpuak.ch

Service Support
Software
The Service Support Software contains the program and supporting
files necessary to run the automated performance tests and
adjustments for your signal generator. This section lists the equipment
required to run the software, and gives instructions for installing and
using the software. Refer to the previous section for a description of
each automated adjustment and refer to Chapter 8 for a description of
each automated performance tests.
The part number for the service support software is listed in ‘Iable 6-l
and Table 6-2.
Required Test The following equipment is required to run the software:
Equipment Personal Computer (PC) with the following specifications:
386/33 MHz CPU or better
At least 8 Mbytes of RAM
Hard Drive with at least 350 Mbyte free
16-Color VGA Monitor or better
3.5inch disk drive
MS Windows version 3.x or MS Windows 95
This version of the service support software will not operate
properly with MS Windows NT.
2 Button Mouse (optional)
Printer, MS Windows-supported (for test results documentation)
HP 82341C HP-IB Interface Card
16-bit HP SICL Libraries must be installed and configured.
Caution Do not install this software program on your computer if the ESG
Series Support Software, Version A.02.02 or earlier, is installed on it.
Windows NT@ is a U.S. registered trademark of Microsoft
Corporation.
Adjustments 7-35