Stereo Scan 440 - DCU

'" Chapter 6 Fault Diagnosis 6-J 7..
'-I L_.lIIJ_UII..I___~ " ~ "--~--" - -: ,":'
IMEX FAILED TO INITIALISE
This is an internal software error which should not occur.
If the fault should occur please. Contact Leica.
INCORRECT WENT CODE
This error occurs when the user interface attempts to access a system parameter
in the Master DLL using an incorrect identification code. Contact Leica.
INV ALm DEFAULT. V AC FILE
Configuration and calibration information relating to the column is saved in Non
Volatile RAM. The ftle containing the initial default data is COf111pt. an
incompatible version or not found.
Please report the problem.
INVALm PARAMETER RECEIVED BY EDT SET
This error is given when the EHT set receives a command with invalid
parameter( s ).
This may be symptomatic of a communications error.
Please report the problem.
INVALID STAGE COMMAND
This error is given when a command is issued to move the stage to an invalid
position (i.e. beyond the limits). This may be due to defining an invalid stage
scan pattern which would result in limit violation.
INV ALID STATE VALVE
This error occurs when the user interface attempts to set a system parameter in
the Master DLL to an incorrect state. Contact Leica.
NO BITMAP IN CLIPBOARD
This failure is given when pasting an image from clipboard.
The clipboard does not contain a bitmap.
Stereoscan 440 Operator Manual