Stereo Scan 440 - DCU

A detector may require some reso~ in order to be configured and will have
empty slots where these may be inserted. If a detector is not fully configured it
cannot be picked up and suitable resources will be identified by a RED border.
~
The
If a detector is fully configured it may be picked up and a suitable empty
connector slot will be coloured RED if one exists.
resource requirements of auxiliary detectors must be correctly
specified.
Detector Resources
Detectors may require none, one or two of the following:-
PMl, PM2, PM3 : Photo multiplier supplies from the EHT set
BSDA: Back scattered Detector Amplifier.
. SCMA: Specimen Current Monitor Amplifier.
The parking area for these objects when not in use is the left side of the screen.
A resource when picked up will cause the appropriate potential empty slots in
detectors to be coloured RED.
Resources may not be unplugged from detectors in use (i.e. plugged into
connectors) .
1.10. RS232 Remote Control
Introduction
This option provides remote control of the S400 via an RS232 input port. The
RS232 licence is required for this option. A document specifying the protocol
used is available under a non disclosure agreement.
Operation
Configuration
The communications characteristics of the port to be used should be defined in
WIN.INI
e.g.
[ports]
COMl:=9600,n,8,l,x
Stereoscan 440 Operator Manual