Stereo Scan 440 - DCU

Angular Measurement
Each measurement object has two handles; one at each end, these may
be moved to redefme the line.
Selecting the measurement parameter An in the annotation panel while
in Edit mode, or selecting the parameter in the status list, will prompt
for a new value. If a new value is entered the reference line remains
fIXed and the other line rotates to the specified angle.
Radial Measurement
Vector Prorlle
Each measurement object has 9 handles; cenb'e, N, S, E, W, NE, NW,
SE, SW.
The centre handle moves the entire object without change in diameter.
The N. S. E. W handles adjust the diameter with the diametrically
opposed point remaining fIXed.
The NE, NW, SE, SW handles adjust the diameter with the centre
remaining fIXed.
Selecting the measurement parameter Dn in the annotation panel while
in Edit mode, or selecting the parameter in the status list. will prompt
for a new value. If a new value is entered the object is altered to the
specified diameter with the centre point remaining fixed.
The measurement line has two handles; one at each end, these may be
moved to redefme the line.
Selecting the Profile Width parameter in the annotation panel while in
Edit mode, or selecting the parameter in the status list, will prompt for a
new value.
The profile cursors will be positioned to reflect the value entered. This is
achieved by first moving the right cursor. The left cursor is moved if
necessary.
Stereoscan 440 Operator Manual