Stereo Scan 440 - DCU

E-32 Appendix E Qptions
.
.
High User Limit
High Inner Limit
High outer Limit
The current limit state may be displayed in the Slams window by selecting the
parameters X limit hit. Y Limit hit and Z limit hit.
A user limit is a software limit. They may be selected in the status window (Stage
High X, Stage Low X, Stage High Y, Stage Low Y, Stage High Z and Stage Low
Z). To change a user limit click on the required limit and enter the value. Note
the limits may be set by a macro.
If a user limit is hit a warning is given and the stage slowed to a halt. Position is
not lost.
If an Inner limit is hit the motor is slowed to a halt and the axis may only be
moved away from the limit.
If an outer limit is bit the motors are stopped and may only be moved manually.
Position is lost.
If the touch alarm is detected a buzzer is sounded, an error is given, position is
lost and the motors must be moved manually until the buzzer is silent.
Controls
Stage Initialisation
The Stage lnitialisation panel is used to define the actual position and is
displayed by Top Menu - StageNac - Stage lnit. On initial installation, or if an
axis outer limit limit has been hit, or if the touch alarm has occurred the stage
position is unknown. The Stage lnitialisation panel is used to define the actual
position and is displayed by Top Menu - StageNac - Stage lnit.
Stereoscan 440 Operator Manual