Stereo Scan 440 - DCU

More documents

Recommendations

Info

Microsoft@ MS-DOS@ 5.0 Microsoft@ Window~ 3.1 Microsoft Word for WindoWSnr 2.0 Microsoft@ Exce~ 4.0 Microsoft@ Visual Basi~ 1.0 Zenographics Super Print 2.2 Micrograrx@ Picture Publisher@ 3.0 Novell@ Netw~ 3.11 Adaptec ASPI SCSI Disk Module 3.0 This list is by no means a commitment of Leica Cambridge to support any of the above. It is most strongly recommended that only Leica supplied and distributed and proprietary branded software is used with this instrument. Leica will bear no responsibility for software corruptions or viruses caused by using pirated or suspect copies of any software. Indeed Lelca reserve the right to take any action they deem necessary. in the event of a virus rmding its way back to the factory from a corrupted instrument we have had to visit. It is also highly recommended that back-ups are made regularly, especially of important and valuable data such as images. Slereoscan 440 Operator Manual
Appendix ~ The Stereoscan 440 PC! AT backplane consists of six 16-bit standard AT bus slots. two of which are used. If the Stereoscan 440 has any factory fitted options. then some of the free slots may be occupied. for example the WORM drive interface occupies one slot. Each card that is installed must not interfere with the cards already installed on the bus. There are four areas in which a card may interfere with the ex.isting hardware. memory. I/O. DMA channels and interrupts. The following sections deal with each of these areas in turn. Space is provided in each table which may be used to record the settings of installed cards. Memory The standard PC memory map for DOS reserves space in the 640kB to 1 MB range for ROM BIOS code and display memory. The gaps left between the standard components are available for other options. For example a network card may have a small amount of SRAM in which to buffer communicated data, this SRAM would be configured in a spare address in the 640kB to 1MB range. Address AO(XX)-BFFfF COOOO-C7FFF The following shows the memory map of a standard Stereoscan 440 in the 640kB to IBM range:- C8000-C}o-pf'F- ~DFFfF EOOOO-t!.I'-I-1'1'- RXX)O-FFfFF Descri VGA VGA BI - - Leica Hardware I System BIOS ROM There are two regions available for use by optional cards, C8000 to CJ:'"J:'"J:'J:' and EOOOO to EFFFF. Any extra cards fitted should therefore be configured to use a range in these areas. Stereoscan 440 ODeraror Manual
Page 2 and 3:
All reasonable steps have been take
Page 4 and 5:
Instrument Photographic Choice of I
Page 6 and 7:
iv Contents Chapter 5 - Maintenance
Page 8 and 9:
The specimen chamber of the Slereos
Page 10 and 11:
The User Interface Overview The use
Page 12 and 13:
5. Panel Selection There is one oth
Page 14 and 15:
B If B is pressed. the arrow keys m
Page 16 and 17:
The top window, see Figure 1.3, pro
Page 18 and 19:
Individual items can be selected or
Page 20 and 21:
1~1~ Chapter 1 Getting Started i '
Page 22 and 23:
all the operating conditions of the
Page 24 and 25:
1-20 ~bapter 1 ~g S~ move the mouse
Page 26 and 27:
FIgUre 1.10 Image of First Peak Set
Page 28 and 29:
Chapter 2 This chapter contains the
Page 30 and 31:
Chapter 1. Operation 2--3 " -- Scan
Page 32 and 33:
Chapter 2. Operation 2.,.,5 ,- . ..
Page 34 and 35:
, , Chapter 1. ~ - 2-- 7 ""a-uu"" 1
Page 36 and 37:
1. Admit air to the gun. Open the g
Page 38 and 39:
Automatic Stage lnitialise The stag
Page 40 and 41:
For LaB,:- 1 Press the Emission but
Page 42 and 43:
~I.~ Chapter 2 Operation -'--"=-,'Z
Page 44 and 45:
2-18 Chapter 1. Operation - - - - a
Page 46 and 47:
2-20 Chapter 2. Operation. 1 2 t Se
Page 48 and 49:
2-22 Chapter 1. Operation If the wo
Page 50 and 51:
2-24 Chapter 2 Operation The Zone T
Page 52 and 53:
Quad Mode Quad mode is selected fro
Page 54 and 55:
2-28 Chapter 2 Operation . - -, , "
Page 56 and 57:
On the histogram display there is a
Page 58 and 59:
Panels A panel is a special kind of
Page 60 and 61:
current text string). In addition t
Page 62 and 63:
Micron Markers Two types of micron
Page 64 and 65:
Graticule and Crosshairs Graticule
Page 66 and 67:
HRRU Camera This sets the type of c
Page 68 and 69:
2..42 Cbapter 1. Operation ~ I It h
Page 70 and 71:
current when the image was saved. T
Page 72 and 73:
2-46 Chapter 2 Operation The Clipbo
Page 74 and 75:
Having now become familiar with the
Page 76 and 77:
high a probe current, thus the acce
Page 78 and 79:
, Chapter 3 Advanced Operation 3-5
Page 80 and 81:
3. The retractable backscattered el
Page 82 and 83:
I~.." - Chapter 3 Advanced Operatio
Page 84 and 85:
"".~-I Chapter 3 Advanced Operation
Page 86 and 87:
" Chapter 3 Advanced Operation 3-13
Page 88 and 89:
Non-Volatile, Non-Conductors If it
Page 90 and 91:
The solvent is then allowed to evap
Page 92 and 93:
Chapter 3 Advanced ~OD 3-19 -c - -
Page 94 and 95:
Other Menu Features The display of
Page 96 and 97:
Points and Steps In addition to the
Page 98 and 99:
Confirm This instruction check that
Page 100 and 101:
._~ Chapter c" ~ 3 Advanced Operati
Page 102 and 103:
Remove Removing a macro from a libr
Page 104 and 105:
The position in the list can be con
Page 106 and 107: Install The install option copies t
Page 108 and 109: Chapter 3 AdvancedOperati on 3-35 3
Page 110 and 111: I I PARAMETER I En"ECT OPTIMUM COMM
Page 112 and 113: 4.5. Good Housekeeping, i.e. keepin
Page 114 and 115: Chapter -. 4 System Management - +3
Page 116 and 117: 4.1.5. Directory Contents I \nGA i
Page 118 and 119: 4.3. The User Directory Concept A u
Page 120 and 121: I this be reql!i~. File Types, e.g.
Page 122 and 123: 6-12 Chapter 6 Fault Diagnosis The
Page 124 and 125: 5-2 Chapter 5 Maintenance 5.1.2. Ai
Page 126 and 127: STEEL AND ST ~S STEEL, COPPER AND m
Page 128 and 129: 5-6 Chapter 5 Maintenance Cleaning
Page 130 and 131: Cleaning the Aperture Assembly Vent
Page 132 and 133: PC Related Faults PC related proble
Page 134 and 135: 6-4 Chapter 6 Fault Diagnosis , .".
Page 136 and 137: 6-6 Chapter 6 Fault Diagnosis The I
Page 138 and 139: 6-8 Chapter 6 Fault Diagnosis . 4.
Page 140 and 141: 6-10 Chapter 6 Fault Diagnosis! "I
Page 142: This file contains the configuratio
Page 145 and 146: Please report the problem. F All..E
Page 147 and 148: Stereoscan 440 Operator Manual NVRA
Page 149 and 150: 6-20 Chapter 6 Fault Diagnosis 4 WW
Page 151 and 152: Code numbers greater than 40 indica
Page 153 and 154: WINDOWSTM APPUCA nON ERROR When a W
Page 155: Introduction As new Window~ applica
Page 159 and 160: " c., Appeudb C Expansion via the P
Page 161 and 162: Appendix D Reporting software probl
Page 163 and 164: Service Manager - SEM Harry M azal
Page 165 and 166: B-2 Appendix E Options- . Operation
Page 167 and 168: Controls Angular Measurement The an
Page 169 and 170: Angular Measurement Each measuremen
Page 171 and 172: The position of the box can be adju
Page 173 and 174: I Set the magnification to the requ
Page 175 and 176: Positioning the Poin~ In Move mode
Page 177 and 178: &14 Appendix E Options I II Image D
Page 179 and 180: ~ AMaxB This function freezes the i
Page 181 and 182: Histogram Equalisation The histogra
Page 183 and 184: Overview The input LUT is used to p
Page 185 and 186: E-22 Appendix E Options Sawtooth Th
Page 187 and 188: A group box at the top left of the
Page 189 and 190: " The communication port used by th
Page 191 and 192: Selection I The signal mixing panel
Page 193 and 194: E- 30 Appendix E Options Select one
Page 195 and 196: E-32 Appendix E Qptions . . High Us
Page 197 and 198: . The stage Move window comprises a
Page 199 and 200: Keyboard Control The cursor (arrow)
Page 201 and 202: E-38 Ap~ ~ Options In addition Macr
Page 203 and 204: Grainl Grain2 actionedl I To indica
Page 205 and 206: The function is provided as part of
Page 207 and 208:
Operation Selection Operation of th
Page 209 and 210:
Stage Scan Invalid This indicates i
Page 211 and 212:
E-48 Appendix E Options ~-",,-;,,~_
Page 213 and 214:
Freeze This function will freeze th
Page 215 and 216:
1.21 Trackerbal/ Introduction This
Page 217 and 218:
Controls Display the pop up control
Page 219 and 220:
Operation Configuration XRay Interf
Page 221 and 222:
E-58 Appendix E Options 11_- X Ray
Page 223 and 224:
Intensity Dot Map Set Up In dot map
Page 225 and 226:
The Linescan data is displayed in a
Page 227 and 228:
E-64 AppeDdjx E ~oos ... ~~ full sc
Page 229 and 230:
Annotation A set of annotation labe
Page 231 and 232:
2. 2.1 Stage Motorisation The stage
Page 233 and 234:
Camera Image Select between Live, S
Page 235 and 236:
If the box marked Fast is selected,
Page 237 and 238:
Remove the Camera assembly from the
Page 239 and 240:
~--~- ~- , -~~::~ '#:r: .TungsIen F
Page 241 and 242:
.,, , or_~ :---1 ' ' --~... 'FG'-~-
Page 243 and 244:
Figures 9,10,11,12 Emission Images
Page 245 and 246:
Assembly Assembly . of the STEM det
Page 247 and 248:
4. Select SCM Image from the Specim
Page 249 and 250:
~ ~ ~ ~ E I I I I I I Stereoscan 44
Page 251 and 252:
DOS, 4-1 Dose rate, 3-12 Dual magni
Page 253 and 254:
1-4 Index Rotary pump Oil. 5-2 Oil
Page 255:
Appendices s+Shift ff ~ I ARRO~ ~ys
show all

Stereo Scan 440 - DCU

Create successful ePaper yourself

Delete template?

Save as template?