Stereo Scan 440 - DCU

Appendix E Options &59
InteDSity
This radio button selects the intensity dot map mode. Adjacent to this button is a
Combo Box to define which data is to be collected. The scroll bar in the same row
as the intensity radio button defines the count value which will represent the
maximum colour brightness. At it's left position only 2 counts will be required to
give the full colour value and at it's right position a count of 128 will be required
to give the full colour value.
Linescan
This button selects Xray Linescan if the Xray Linescan licence is present
Xray Menu: Save
This command saves the current Xray set up to a file with the extension XRS in
the user directory .
Xray Menu: Load
This command loads the Xray set up from a ftle with the extension XRS in the
user directory .
Xray Menu: Start/Stop
These commands start and stop the Xray acquisition.
Xray Menu: Cear
This command clears both the Xray and Grey planes
Xray Menu: Default
This function resets the Xray set up to the default state.
Procedures
General
On entry to the Xray set up window the normal mode display LUT contents are
stored and the display LUT switched into Xray nxJde.
There are three parts to the dot map function:-
a)
b)
c)
set up of the required function
data acquisition
colour coding of the display LUT
Closing the Xray window will give an XRayReset which stops X ray acquisition
and restores the display LUT to Normal mode.
Stereoscan 440 Operator Manual