Stereo Scan 440 - DCU

HRRU Camera
This sets the type of camera being used, this will affect the magnification value of
the fmal image.
HRRU Brightness and Contrast
These parameters are best set using the grey wedge (from the output LUT set up
menu). The brightness should be adjusted until the darkest level is just black and
the contrast should then be adjusted until the brightest level is white.
Development Timer
The Development Timer is a simple count down timer which 'Beeps' on
completion. The duration (in seconds) can be entered by clicking on the time.
The timer is initiated with the start Development Timer button.
Photo Number
The photo number increments each time an image export is performed
(regardless of output device). Besides appearing in the HRRU panel, it can also
be displayed in the status window or used as annotation. It can be set to a new
value by clicking on it whenever it appears.
In addition to the fields mentioned above, the Photo and Abort photo buttons
operate in the obvious way.
2.6.2. Video Printers
The sequence of operation to take a video print is as follows:-
Ensure the video printer is selected as the current output device.
2. Optimise the brightness and contrast of the image.
3. Apply any noise reduction and freeze the full size image to be printed.
4. Select photo icon with the right mouse button.
5 Set up the required size and orientation.
6. Select OK to initiate the print sequence.
Stereoscan 440 Operator Manual