Stereo Scan 440 - DCU

Introduction
As new Window~ applications are being created and updated from week to
week, it is impossible to keep track of each one as it becomes available.
Although a standard is slowly emerging for installing these third party
applications, each application usually still has a unique set-up procedure.
A general set of guidelines however should be considered before installing any
Window~ application on your system.
. Always back-up your system disk before modifying it. The easiest way
is to simply back-up you configuration files only; such as:
\CONFIG.SYS, \AUTOEXEC.BAT,
\ WINDOWS \ * . INI , WINDOWS \ * . GRP. Although this is not a
.
complete back-up, most of the old system configuration ftles will have
been saved.
Always read the application manual thoroughly before starting any
installation.
Always check that your hardware configuration is compatible with this
application.
Always check that you have at least the recommended hard disk space
free for the application - use WindowsTM File Manager.
With Microsoft@ Applications, choose Express Set-up if this option is
available.
. Only choose advanced. or custom installation options if you are
confident that you will be able to answer all the questions the
installation program may ask you. These options usually require a good
knowledge of how DOS, or the specific WindowslM Application works.
Below is a list of applications already installed and tested on Leica Stereoscan
400 Series SEMs. If you are in any doubt as to the coIi1patibility of a third party
application you wish to install, telephone Leica Customer Care Department (44)
223411411 or fax (44) 223 412776.
Stereoscan 440 Operator Manual