Agilent 34970A/34972A Data Acquisition / Switch Unit

Chapter 4 Calibration Procedures
Relay Verification
Note: Connect bare copper wires (approximately 3 cm in length) to the I
terminals of Channels 21 and 22 as shown below. These wires will be
used to make shorts across the channels in Tests 6 through 39.
Note: Be sure to probe the components at
the indicated locations on the module.
Probe here
for L402
measurement.
Probe here for F501 measurement.
Probe here for F502 measurement.
Connections for 34901A Verification Tests 1 through 5
100