Agilent 34970A/34972A Data Acquisition / Switch Unit
Agilent 34970A/34972A Data Acquisition / Switch Unit
Agilent 34970A/34972A Data Acquisition / Switch Unit
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 4 Calibration Procedures<br />
Relay Verification<br />
Tests 9 - 10:<br />
Open all channels on the module by performing a Factory Reset.<br />
Configure Channel 10 (module in slot 200) as follows: 4-wire ohms, 1 k<br />
range, and 5½ digits.<br />
Enable reading monitoring by pressing on the selected channel (or<br />
use the ROUTe:MON command). Record the 4-wire ohms measurements<br />
from the external DMM in the following table.<br />
External DMM Ohmmeter Connections<br />
Test<br />
#<br />
Channel<br />
Configured HI LO<br />
HI<br />
Sense<br />
LO<br />
Sense<br />
Measured Value<br />
Test<br />
Limit<br />
Relay<br />
Measured<br />
9 Ch 10 P2 P2 P3 P3 ________Ohms — —<br />
10 Subtract (Test 9 - Test 3) ________Ohms 2.00 K423<br />
Tests 11- 33:<br />
Open all channels on the module by performing a Factory Reset. For<br />
each test, close only the channel shown in the “Channel Closed” column<br />
below (module in slot 200). Turn the Monitor Mode “off” and select<br />
“Banks Joined” from the Advanced menu. Record the 4-wire ohms<br />
measurements from the external DMM in the following table.<br />
External DMM Ohmmeter Connections<br />
Test<br />
#<br />
Channel<br />
Closed*<br />
HI LO HI<br />
Sense<br />
LO<br />
Sense<br />
Measured Value<br />
Test<br />
Limit<br />
Relay<br />
Measured<br />
11 Ch1 P2 P2 P1 P1 ________Ohms 2.00 K401<br />
12 Ch 2 P2 P2 P1 P1 ________Ohms 2.00 K402<br />
13 Ch 3 P2 P2 P1 P1 ________Ohms 2.00 K403<br />
14 Ch 4 P2 P2 P1 P1 ________Ohms 2.00 K404<br />
15 Ch 5 P2 P2 P1 P1 ________Ohms 2.00 K405<br />
16 Ch 6 P2 P2 P1 P1 ________Ohms 2.00 K406<br />
17 Ch 7 P2 P2 P1 P1 ________Ohms 2.00 K407<br />
*Only the channel currently under test should be closed at one time. All other channels should be open.<br />
Continued on next page...<br />
102