Agilent 34970A/34972A Data Acquisition / Switch Unit
Agilent 34970A/34972A Data Acquisition / Switch Unit
Agilent 34970A/34972A Data Acquisition / Switch Unit
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 2 Quick Start<br />
To Prepare the Instrument for Use<br />
To Prepare the Instrument for Use<br />
1 Check the list of supplied items.<br />
Verify that you have received the following items with your instrument.<br />
If anything is missing, contact your nearest <strong>Agilent</strong> Technologies Sales<br />
Office.<br />
• One power cord.<br />
• One User’s Guide.<br />
• This Service Guide.<br />
• One Quick Reference Guide.<br />
• Certificate of Calibration (if you ordered the internal DMM).<br />
• BenchLink <strong>Data</strong> Logger 3 Software CD-ROM.<br />
• Quick Start Package (if you ordered the internal DMM):<br />
• One RS-232 cable.<br />
• One J-type thermocouple and a flatblade screwdriver.<br />
• Any plug-in modules that you ordered are delivered in a separate<br />
shipping container.<br />
4<br />
2<br />
On/Standby<br />
<strong>Switch</strong><br />
WARNING<br />
Note that this switch<br />
is Standby only.<br />
To disconnect the<br />
mains from the<br />
instrument, remove<br />
the power cord.<br />
2 Verify that the fuse on the back is set to the proper voltage range<br />
for your AC power.<br />
3 Connect the power cord and turn on the instrument.<br />
The front-panel display will light up briefly while the instrument<br />
performs its power-on self-test. The instrument initially powers up with<br />
all measurement channels turned off. To review the power-on display<br />
with all annunciators turned on, hold down as you turn on the<br />
instrument. If the instrument does not turn on properly, see page 50.<br />
4 Perform a complete self-test.<br />
The complete self-test performs a more extensive set of tests than those<br />
performed at power-on. Hold down as you turn on the instrument<br />
and hold down the key until you hear a long beep. The self-test will begin<br />
when you release the key following the beep.<br />
43