CinePlex v3 Manual - Plexon Inc

6 Connect a push button switch (09-40-A-01) to the BUTTON input of the Quad
MAP Controller using a standard BNC cable.
7 Connect the START BNCs on the QMC to the XS2 BNC on the TIM board of
each MAP system using equal length BNCs.
8 Connect the CLK OUT BNCs on the QMC to the CLK BNC on the TIM board
of each MAP system using equal length BNC cables.
9 (Optional) Connect the DIGITAL INPUT on the QMC to a behavioral control
system. Use the same cable that would normally connect the behavioral
control system directly to a MAP system. Connect the DIGITAL OUTPUT
Version 3.0 109