CinePlex v3 Manual - Plexon Inc

5
checked, CinePlex Editor snaps both the start and the end times to their
respective best match occurrences. This can change the length of the interval.
When the checkbox is cleared, CinePlex Editor uses the best match to the
start time to shift the entire interval. In this case, the end time shifts by the
same amount as is the start time, so the length of the interval remains constant.
5.3.7.6 Interpolate Missing Occurrences
This item opens the Interpolate Missing Occurrences dialog box. An illustration
of the dialog box follows:
• Marker - From the drop-down list, select the marker to interpolate.
• Periodicity - This box displays the periodicity results for the selected
marker as follows:
— Tolerances for Gaps – For the gap analysis, the average separation
between markers is determined. If the time gap between any two adjacent
marker occurrences is not within the Tolerance for Gaps value (i.e.
between (1-TFG) and (1 + TFG) times the average separation, it is
marked as a gap.
— pairs – the number of pairs of adjacent times
— avg – the average time difference between pairs in seconds
— stddev – the standard deviation around the average time difference
— min – the smallest time difference encountered in seconds
262 CinePlex