CinePlex v3 Manual - Plexon Inc

3
• Location – This setting allows the user to determine where the timecode will
display on the screen. Choices are upper left, lower left or upper right, lower
right.
• Format – This setting allows the user to determine the format of the displayed
timecode. Choices are HH:MM:SS.NNNN and SSSSS.NNNN.
3.2.1.2.4 Calibration Group.
The Calibration group contains the following settings:
• Use Calibration - checking this checkbox causes Studio to use calibration
• Units - this setting (cm or in) specifies the calibration units
• Type - this setting indicates the number of calibration bars (One-Bar or Two-
Bar).
• Color - this setting indicates the color of the reference bar(s).
• Global Factor - this setting specifies the factor of global calibration. This setting
is present only if the Type setting is One-Bar.
• Reference Size - this setting is present once if the Type setting is One-Bar
and twice if the Type setting is Two-Bar (one associated with the Horizontal
Factor and one associated with the Vertical Factor). It contains two sub-settings:
— Video (pixels) - this setting is the size of the reference bar in pixels.
— Actual (cm) or Actual (in) - this setting adjusts the actual size of the
reference bar in centimeters or inches depending on the Units setting.
• Horizontal Factor - this setting contains the horizontal calibration value.
There is a Reference Size section under Horizontal Factor.
• Vertical Factor - this setting contains the vertical calibration value. There is
a Reference Size section under Vertical Factor.
126 CinePlex