CinePlex v3 Manual - Plexon Inc

• Delete selected tracking event - - this button deletes the selected
event from the pane.
3.2.2.3.2 Event Group. There are two events in the image shown, and each event
has several settings:
• Name - the name of the event
• Color - the color of the event
• Target - the type of target (Zone, Sequence, Speed, Head Direction). Target
will have sub-settings based on the target type selected in the dropdown:
— Zone Sub-settings
– Zone - dropdown selectable values of zone names
– Condition - dropdown selectable values of Entering Zone and
Leaving Zone.
Note:
Note:
There is a small delay (dwell time) between the occurrence of the zone event
and its condition going to the TRUE state. However, when the zone event is finished,
the event condition will go FALSE immediately (in the first video frame
following the end of the event).
— Sequence Sub-settings
– Sequence - dropdown selectable values of sequence names
— Speed Sub-settings
– Value Threshold (pixel(s)) - this setting determines the speed
threshold. If the instantaneous speed of the object is lower or higher
(determined by the Condition setting) than this setting during a
period of time set by the Time Threshold setting, the event is considered
to have occurred. The range of values is from 0 to 1000.
There is a small delay (dwell time) between the occurrence of the speed event
and its condition going to the TRUE state. However, when the speed event is
finished, the event condition will go FALSE immediately (in the first video frame
following the end of the event).
– Time Threshold(s) - this setting (in seconds) works with the Value
Threshold setting and the Condition setting to determine if the
event occurs. The range of values is from 0.0 to 10.0.
– Condition - dropdown selectable values of Higher than value
threshold and Less than value threshold.
— Head Direction Sub-settings
– Value Threshold (grad.) - the event is considered to have occurred
if the head direction angle is higher or lower (determined by the
Version 3.0 143