Banner Faculty and Advisor Self-Service / User Guide / 8.3

Setup Requirements
Item
Originator Code Validation
Form (STVORIG)
E-mail Address Type
Validation Form
(GTVEMAL)
Compliance Print Code
Validation Form
(STVPRNT)
Compliance Type Code
Validation Form
(STVCPRT)
Crosswalk Validation Form
(GTVSDAX)
Description
The Web code is used for recording where a compliance had
been requested from. When a request is made, the Origin
Code field on the Compliance Request Management Form
(SMARQCM) is populated with Web.
Create a code for student and faculty/advisor e-mail. This
code is used to populate the student and faculty e-mail on the
WebCAPP Rules Form (SMAWCRL).
Create a code for use with degree evaluations on the Web.
This code should be entered in the Print Type field on the
WebCAPP Rules Form (SMAWCRL), if you choose to use
print types. This code is also used for the print code in CAPP
for its display; including program, area, group, and rule text.
Single text type only.
Create a code for use with degree evaluations on the Web.
This code should be entered in the Compliance Type field
on SMAWCRL, if you choose to use compliance types. This
code is also used to determine print codes in CAPP for its
display; including program, area, group, and rule text.
Multiple text types: Met/Not Met).
See the “Crosswalk Validation Form (GTVSDAX) Records
for WebCAPP Processing” on page 7-70.
WebCAPP Rules Form (SMAWCRL)
This form is used to set up the controls for the WebCAPP rules for evaluation requests.
The following controls are displayed on the form:
• What-If Analysis Display
• Evaluation Display
• Expanded Requirements (This will be included in a future release.)
• Faculty Control
For detailed information about SMAWCRL, see the CAPP Handbook.
7-68 Banner Faculty and Advisor Self-Service 8.3 December 2009
User Guide
Student Information