Blackmagic ATEM Manual - Concept Music Art
Blackmagic ATEM Manual - Concept Music Art
Blackmagic ATEM Manual - Concept Music Art
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
76<br />
Operating Your <strong>ATEM</strong> Switcher<br />
Performing an Upstream Pattern Key<br />
To set up a pattern key on upstream keyer 1 on the software control panel:<br />
Step 1. Expand the upstream key 1 M/E 1 palette and select pattern from the key types bar.<br />
Step 2. Select the fill source.<br />
Step 3. Select the key pattern.<br />
Step 4. Adjust the key parameters to refine the key. For a description of pattern key parameters, refer to<br />
the table below.<br />
To set up a pattern key on upstream keyer 1 on the broadcast panel:<br />
Step 1. Press the KEY 1 button to enable the keyer on the preview output. The system control will<br />
dynamically navigate to the KEY 1 menu. You can manually navigate to the KEY 1 menu by<br />
pressing HOME > EFFECTS KEYS > KEY 1.<br />
Step 2. Select the PATTRN KEY menu button.<br />
Step 3. The destination display will say key1fill. Select the fill source on the select bus. Since the key signal<br />
is automatically created by the internal pattern generator from the fill source, the cut source is<br />
ignored.<br />
Step 4. Select the PATTRN MENU button and use the menu buttons to select a pattern.<br />
Step 5. Adjust the pattern key controls to refine the key.<br />
Pattern Key Settings<br />
Pattern key parameters:<br />
Size<br />
Symmetry<br />
Soft<br />
Inverse<br />
Fly Key<br />
Increases and decreases the size of the selected pattern.<br />
Some of the patterns may have their symmetry or aspect ratio adjusted. Circle<br />
patterns may be adjusted to become horizontal or vertical ellipses. The symmetry<br />
adjustment is on the z axis of the joystick when you are on the pattern selection<br />
page of the keyer you are setting up. Twist the knob of the joystick to adjust its<br />
symmetry.<br />
Changes the softness of the edge of the key signal.<br />
The reverse button is used to invert which region is filled with the fill source. For<br />
example, fill a region outside of a circle by positioning the circle wipe as desired<br />
and then selecting inverse.<br />
Enables/disables DVE effects