F4200N Manual - Fisnar.fr
F4200N Manual - Fisnar.fr
F4200N Manual - Fisnar.fr
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>F4200N</strong> Operating <strong>Manual</strong><br />
Section 3: Teaching Overview<br />
Part # 562187N<br />
Rev. C Jun 2011<br />
3.5 Setup Menu (F4)<br />
Below is a list of functions, which are found under the F4 key (Setup menu):<br />
Function<br />
Line Speed<br />
Line Dispense Setup<br />
Point Dispense Setup<br />
Dispense End Setup<br />
Z Clearance<br />
XY Move Speed<br />
Z Move Speed<br />
Home Position Setup<br />
Description<br />
Registers the LINE SPEED used for all lines <strong>fr</strong>om the<br />
current memory address forward until another Line<br />
Speed instruction is found.<br />
Registers the LINE DISPENSE SETUP values which<br />
sets dispensing wait time at the start of lines („head‟<br />
time), wait time at the passing points („Node‟ time) and<br />
waiting time at the end of lines („tail‟ time). The<br />
registered values will be used <strong>fr</strong>om the current memory<br />
address forward until another Line Dispense Setup<br />
instruction is found.<br />
Registers POINT DISPENSE SETUP values, which sets<br />
dispensing time and waiting time at the end of<br />
dispensing („tail‟ time) for dots. The registered values will<br />
be used <strong>fr</strong>om the current memory address forward until<br />
another POINT DISPENSE SETUP instruction is found.<br />
Registers the height and speed the tip should raise at<br />
the end of dispensing. The registered values will be<br />
used <strong>fr</strong>om the current memory address forward until<br />
another DISPENSE END SETUP instruction is found.<br />
Registers the addition distance the tip should rise,<br />
beyond the height set in Dispense End Setup, to allow<br />
obstacles to be cleared as the tip moves <strong>fr</strong>om one figure<br />
to another. Values will be used until another Z Clearance<br />
instruction is found.<br />
Sets the movement speed of the X and Y axes when<br />
moving <strong>fr</strong>om one figure to another in the program<br />
Sets the movement speed of the Z-axis when moving<br />
<strong>fr</strong>om one figure to another in the program<br />
Changes the position the robot moves to at the end of a<br />
program cycle.<br />
- Page 21 - © 2011 <strong>Fisnar</strong> Inc.