F4200N Manual - Fisnar.fr

F4200N Operating Manual
Section 4: Programming Example
Part # 562187N
Rev. C Jun 2011
3. Editing a Program
You can move through the instructions in an existing program by using the following keys:
Key Function
+1 Moves forward (1) memory address
-1 Moves backward (1) memory address
FIRST Moves to the first memory address in the program
END Moves to the last programmed memory address in the program
+10 Jumps forward (10) memory addresses
-10 Jumps backward (10) memory addresses
MOVE Moves the tip to the XYZ point location of the selected point
JUMP Jumps to display the specified memory address
3.1 Changing a Point’s XYZ location
To change the XYZ location of a point, press the +1 or –1 key until the point you want to
change is shown in the display.
You can confirm that the correct point is in the display by pressing the MOVE key. This will
cause the tip to move to the XYZ position shown in the display.
Now use the jog keys (X, X, Y and Y) and the Z / Z keys to jog the tip to the
new location.
Once the location is correct, simply re-register the point as you did when it was first taught,
by pressing the ENTER key and selecting the point type. The point will be re-registered at
the new location.
3.2 Insert / Delete an Instruction
To insert an instruction, press the INS key. The point currently shown in the display
will be moved forward one memory address. A new, empty memory address will be
inserted at the current memory address.
To delete the instruction currently shown in the display, press the DEL key, and
then press the F1 (Yes) key.
- Page 28 - © 2011 Fisnar Inc.