F4200N Manual - Fisnar.fr

F4200N Operating Manual
Section 5: Point Type & Function Reference
Part # 562187N
Rev. C Jun 2011
2.1.6 Offset
The Offset function allows all XYZ locations in a program to be shifted in the X, Y, or Z-
axis by a user-defined distance.
To use group edit to add 15 mm to all X-axis values in memory address range 1 – 200:
1
2
3
4
5
Instruction
Press the F2 (MENU 1) key, then 1 to select
Group Edit.
The display will prompt the user to enter the
starting memory address of the group to edit
(From) and the ending number of the group to
edit (To).
Type 1 then press ENTER to register 1 in From.
Type 200 then press ENTER to register 200 in To.
The Group Edit menu will then appear, allowing
the user to select an operation to be applied to the
range of points.
Press 6 to select Offset. Then press ENTER.
The display will prompt the user to type the X, Y,
and Z offset amounts to be added to all points in
address range 1 – 200.
Type 15 and press ENTER to add 15 mm to the
X-axis values. Press ENTER two more times to
leave the Y and Z offsets at zero.
The display will now prompt the user to confirm
the change. Press 1 to select Yes. Then press
ENTER.
15 mm will be added to all of the X-axis values in
the selected range.
Display Shows
GROUP EDIT
FROM: 1
TO: 1
(1 4000)
F1: All F2: End
GROUP EDIT
ADDR:1-200
------------------------
1.Copy 5.Dispense Time
2.Delete 6. Offset
3.Move 7.Offset (R.E)
4.Line Speed
Select:
GROUP OFFSET
ADDR: 1-200
------------------------
X Offset:0
Y Offset:0
Z Offset:0
Unit: mm
GROUP OFFSET
ADDR: 1-200
------------------------
X Offset: 15
Y Offset:0
Z Offset:0
1.Yes 2.No
Select:
- Page 58 - © 2011 Fisnar Inc.