F4200N Manual - Fisnar.fr

F4200N Operating Manual
Section 5: Point Type & Function Reference
Part # 562187N
Rev. C Jun 2011
5.10 Retract Setup
The Retract function gives the programmer a high level of tip control at the end of line
dispensing. This is useful when dispensing high viscosity or 'stringy' materials as it will lay
the material‟s tail down on the dispensed bead.
There are five types of the Retract Setup functions: 0 (Normal), 1 (Back), 2 (Square Back),
3 (Forward) and 4 (Square Forward).
_______________________________________________________________________
#0: RETRACT (NORMAL)
_______________________________________________________________________
#1: RETRACT (BACK)
_______________________________________________________________________
- Page 80 - © 2011 Fisnar Inc.