F4200N Manual - Fisnar.fr
F4200N Manual - Fisnar.fr
F4200N Manual - Fisnar.fr
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>F4200N</strong> Operating <strong>Manual</strong><br />
Section 5: Point Type & Function Reference<br />
Part # 562187N<br />
Rev. C Jun 2011<br />
2.3 Program Name<br />
Program Name allows the user to register a name for the current program. If a program<br />
name is registered, it will appear on the display when that program is selected in Run<br />
mode.<br />
2.4 Z-axis Limit (mm)<br />
Z-axis Limit allows the user to limit the range of the Z-axis.<br />
Use the Z and Z keys to bring the Z-axis to the lowest point the Z-axis should be<br />
allowed to travel (the highest Z-axis numeric value), then select F2 (Menu 1), 4. Z-axis<br />
Limit. (mm)<br />
The Z-axis range of motion will be limited to the current value.<br />
2.5 Initial Output Port<br />
Initial Output Port sets the ON/OFF status of the output signals at the start of each<br />
program cycle.<br />
Initial Output Port value is the decimal representation of an 8 binary bit values controlling<br />
the 8 output signals.<br />
For example,<br />
Decimal<br />
Value<br />
Output Status<br />
(X = on, blank = OFF)<br />
#1 #2 #3 #4 #5 #6 #7 #8<br />
0<br />
1 X<br />
2 X<br />
4 X<br />
8 X<br />
16 X<br />
32 X<br />
64 X<br />
128 X<br />
- Page 61 - © 2011 <strong>Fisnar</strong> Inc.
Change language