F4200N Manual - Fisnar.fr
F4200N Manual - Fisnar.fr
F4200N Manual - Fisnar.fr
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>F4200N</strong> Operating <strong>Manual</strong><br />
Section 5: Point Type & Function Reference<br />
Part # 562187N<br />
Rev. C Jun 2011<br />
1.12.2 Brush Area: Circle<br />
Brush Area Circle causes the tip to „paint‟ the defined area by following a spiral path <strong>fr</strong>om<br />
the outside limit of the circle to the center of the circle. It works in reverse of the Circle 1<br />
function.<br />
After registering the Brush Area Circle command, jog the tip to a point on the outside limit<br />
of the circle to be brushed and register that location as a Line Start point. Then jog the tip<br />
directly across to the center of the circle and register that location as a Line End point (the<br />
tip will not dispense a straight line between these two points):<br />
Paint<br />
Line Start<br />
Line End<br />
Area<br />
If, for example, a brush width of 5 mm was used, the tip will take the following path when<br />
the program is run:<br />
Closed Circle: <strong>fr</strong>om Outside of the Circle to the Center Open Circle: <strong>fr</strong>om Center of the Circle to out<br />
An open or closed option is also available for this function. Selecting the Closed option will<br />
make a whole circle first before making the spiral. Selecting the Open option will make the<br />
spiral without closing the outer circle.<br />
- Page 43 - © 2011 <strong>Fisnar</strong> Inc.